1.3 | Preparing the power supply
Place the (+) connector (with fuse holder) in the vicinity of the positive
battery terminal.
Please note:
Do not connect the power supply yet, to prevent a short circuit!
1.4 | Connecting the ground
Connect the (-) connector to the negative battery terminal, or screw it
to a body ground point.
Please note:
Connect the ground after the installation is fully completed.
1.5 | Connecting the signal wire
Plug the white connector into the receiver unit.
2 | Installing the Guerrilla Bypass
2.1 | Preparing the exhaust: defining the spot
•
Ensure you have sufficient working space. For example, lower
the exhaust or detach the rear exhaust section.
•
Select a place just before the end muffler with at least 30 cm of
free space between the front of the valve body and the muffler.
Tip:
Want to simplify the installation? Use a weld cover:
http://www.guerrilla-exhaust.com/en/weld-cover
2.2 | Option A: making a hole for a bend
•
Use the diameter of the supplied 90° bend as a size indicator
and mark the selected spot.
•
Make a hole in the existing exhaust pipe.
•
Grind the exhaust pipe side of the 90° bend so that it nicely
follows the pipe curve.
2.2 | Option B, step 1 of 2: making a hole for a weld cover
•
Use the weld cover as a size indicator and mark the chosen
spot.
•
Remove a rectangular part from the exhaust pipe.
2.2 | Option B, step 2 of 2: placing the weld cover
•
Place the weld cover on the opening.
•
Weld the seams shut.