www.guepardnetworks.com
29 |
P a g e
GC1200ac MANUAL
password in login
3
I cannot login the AP
through WEB management
1. Please make sure PC and ceiling AP’s IP Address are in
same network segment, then check if can Ping AP’s IP
address: PC start‐‐input “and” in Run, then ping
192.168.188.253
2. Login again after Restore this ceiling AP to factory
default.
3. Make sure there isn’t any equipment to take IP address
of 192.168.188.253 in the same network
4
.
Check LAN cable to avoid any problem, recommend do
not use unshielded twisted pair Ethernet cable.
4
I forget the AP’s SSID and
passwords
1. Login to AP’s interface page by internet cable, then reset
password in wireless setting.
2. Restore to factory default
5
I can’t access to AP’s IP
address
1. Check AP’s DHCP and make it enabled in Gateway mode.
2. Check the internet connection between ceiling AP and
the root router/switch in AP and Repeater mode.
6
I can’t access into Internet
even finished the settings of
wireless AP
1
.
If dynamic IP user, login wireless AP’s WEB
page, check Internet settings‐‐WAN Setting‐‐Dynamic IP, fill
in right info
2
.
If ADSL user, login wireless AP’s WEB page, check
Internet settings‐‐WAN setting‐‐PPPOE, then input the right
user name and password
3. Please set PC’s IP address as obtain IP address
automatically
7
How to change IP address in
local network
Click
Advanced
settings‐
Network
‐
LAN
settings‐
IP
address
setting‐
Apply
8
How to Reset Wireless AP
Press and hold the “Reset” button more than 15 seconds
after power on. The Wireless AP will be restored back
factory default after the Wireless AP restart.
