GUDEL CP 3-5 V2, Operating Manual

Page: 209 / 350

9.3.12.3 Eccentric
A B C
E D
Fig. 9-48 Setting the tooth flank backlash: Eccentric
A Fastening screw D Eccentric ring
B Eccentric marking (if present) E Pinion
C Rack
Set the tooth flank backlash as follows:
1 Switch off the system and secure it with a padlock against being switched
on again
2 Check the tooth flank backlash
Ü 2
210
3 If there are deviations:
3.1 Unblocking the eccentric ring
3.2 Slightly loosen fastening screws
3.3 Backlash too large: Turn the eccentric ring away from the rack
3.4 Backlash too small: Turn the eccentric ring towards the rack
3.5 Tighten the fastening screws
3.6 Blocking the eccentric ring
3.7 Repeat process from step 2
The tooth flank backlash has been set.
Maintenance OPERATING MANUAL CP 3-5 V2
9007202252815371_v1.0_
EN-US
209