6
expert net control 2101/2151
Hardware
2) LED Output Port
3) Button "select"
4) Button "ok"
5) Ethernet jack (RJ45)
6) Connector for power supply unit
7) Connector for Sensor 2 (RJ45)
8) Connector for Sensor 1 (RJ45)
9) Terminal clamp Output
3.3
Installation
1.) Connect the power supply cable to the of expert net control 2101/2151 and a socket. expert net control 2101/2151
now is booting and shortly after ready for usage.
2.) Plug the Ethernet cable into the ethernet connector (RJ45) of expert net control 2101/2151 and connect it to your
Ethernet.
3.) Connect the clients to the Power Ports of the device.1.) Connect the power supply unit to the power connector at expert
net control 2101/2151 (6) and a power socket. in case you are using the Power over Ethernet device, there is no need to
connect the power supply unit. expert net control 2101/2151 now is booting and shortly after ready for usage.
2.) Plug the Ethernet cable into the ethernet connector (RJ45) of expert net control 2101/2151 and connect it to your
Ethernet.
3.) Connect the terminal clamp of the output to your device, and plug the sensors into the sensor connectors (RJ45).
3.4
Status LED
The Status LED shows different states of the device:
Status LED red: Device is not connected to the ethernet
Status LED orange: Device is connected to the ethernet, TCP/IP settings are not allocated
Status LED green: Device is connected to the ethernet, TCP/IP settings allocated, device is ready to use
Status LED blinks alternately red and green: Device is in Bootloader mode.
4
Configuration
4.1
DHCP
After switch-on expert net control 2101/2151 looks for a DHCP server and requests an available IP address .
Please check the IP address allocated to expert net control 2101/2151 in the DHCP server settings to make sure that the
same address is used at every reboot.
