16
expert net control 2101/2151
Configuration
4.3.9.1
Enable E-Mail
Here you can activate the e-mail function of the device.
4.3.9.2
E-Mail server
Enter the e-mail server, e.g. [email protected]
4.3.9.3
Sender address
Enter the address, the device should use, when sending e-mails.
4.3.9.4
Recipient address
Enter the e-mail address of the recipient.
4.3.9.5
Enable Authentifiaction
If your e-mail server needs an authentification, you can enter it here.
4.3.9.6
Username
Enter the username, the device should use to log on your e-mail server.
4.3.9.7
Set new password
If your server needs a password for sending e-mails, you can enter it here.
4.3.9.8
Repeat password
Repeat the password, to enable it.
5
Operation
5.1
Switching at the device
expert net control 2101/2151 disposes of two buttons: “select” and “ok”. By pushing “select”, the LED of the Output
starts blinking which means that it is selected. If you want to change the switching state of the selected Output, push the
“ok” button for two seconds.
You can check the status of the Output by the color of the Output LED (green=enabled/red=disabled).
