Installing
1
．
Untighten the screw to open the unit (see fig.1);
2
．
Pull in wires through the out-line hole on bottom cover and then connect wire to terminals on PCB according to connection
line diagram.
3
．
Fixing the bottom cover on needed position( see fig.2)
4
．
Link up front cover and tighten the screws(see fig.3)
Sensor emitter LX-AL8
—
—
—
—
Jumper setting (like right figure)
·
Sense once to emit: after sensing once,
the sensor emit signal
·
Sense twice to emit: after sensing twice,
the sensor emit signal ,
This setting
enhance its preventing false-alarm and
preventing-pet function
.
Note: the emit interval time is at least
15sec.that means: sense to make it emit,
after at least 15sec sense it again, it will emit again.
—
—
—
—
Test
·
press the arm key of remote controller or main controller, set the controller to arm.
·
set the jumper on needed position;
·
install 9V battery, and install the unit on selected position;
·
turn on power switch to switch on power, after 60s the sensor enter stable working state;
·
according to the studying wireless method select study arm zone(2.arm zone) to study LX-AL8;
·
move along the tangent of the lens, the sense LED light and then it emit signal to controller, the emission LED light. the siren give
alarm and the controller dial.
—
—
—
—
Attention
·
Low-battery LED: When battery energy is below 7V, the low-battery LED will flash once a second and remind you replace battery.
·
Avoid installing the unit on metal base;
·
Avoid installing the unit where sun shine or temperature change obviously, for example: air conditioning, heater etc.
Door magnetism LX-DM1
·
Install magnetism and emitter on upright position of door lock, the distance between them is 3mm~5mm and triangle on emitter
aim at triangle on magnetism(like right figure);
·
install DC12V battery into emitter and then close the battery lid;
·
according to the studying wireless method select study arm zone(2.arm zone) to study LX-DM1;
·
press the arm key of remote controller or main controller, set the controller to arm.
·
Open door, the emitter is triggered and its LED light, then emit signal to controller, the siren
alarm and the controller dial
；
·
tamper design: Under the condition that the triangle on emitter aim at triangle on magnetism,
when the battery lid is removed, it will emit signal to controller.
·
Attention:
1
．
．
．
．
Avoid installing the unit on metal base;
2
．
．
．
．
The magnetism should be on the left of the emitter
(like following figure)
Warnning: No slide all numerals of the DIP switch to ON position simultaneously when coding!
Inco rrect po sition
C o rrect po sition
D o o r
D o o r f r a m e
D o o r lo c k
AUTO
DIP switch
Sense LED
Power switch
PIR
Jumper
A
U
T
O
/
1
A
U
T
O
/
1
1
Emit LED
Sense
once to
emit
Sense
twice to
emit
Low-battery LED
78
160
out-line hole
Fig. 1
Fig. 2
Fig. 3