6
To Secure the Rail on the Opener
With the End Segment of the rail fully inserted into the Rail
Bracket, insert a 5/16” x 1-1/2” Clevis Pin through the hole and
lock it into position with a Hitch Pin as shown in Fig.1.
To Assemble the Header Section of Rail
Follow steps shown in Fig.2:
1. Remove the “Trolley Shaft and Cable” from the Chain carton
and lay it beside the rail assembly. Hold Cable Eyelet on the
end of cable and thread about 20” (50cm) through the slot
on the Header Segment of the rail.
2. Temporary insert a screwdriver to the hole on the rail apart
from the slot, slide the trolley to the screw driver and keep
the position.
3. Insert the Pulley into the opening while the cable is hanging.
4. Secure the Pulley by inserting the 3/8” x 1-3/4” Clevis Pin
through the top of the rail.
5. Lock the Clevis Pin with a Hitch Pin. Rotate the Pulley to
ensure it spins smoothly.
Slide the Trolley Shaft into the Trolley until a “click” is heard
when they are connected and locked, as shown in Fig.3.
To Link Cable with Chain
Refer to Fig.4. Place the chain carton beside the rail, hold the
“Chain to Cable Connector” and pull about 8” (20cm) of chain
from the box. Thread the Chain to Cable Connector onto the
Trolley Shaft so that they are loosely linked together.
!
WARNING
To prevent SERIOUS INJURY:
- DO NOT connect power until instructed.
- Keep hands and fingers clear from sprocket during operation.
- Wear gloves when installing chain/belt and cable.
- Keep hands and fingers away from joints and possible sharp edges.
Fig.1
Clevis Pin
Pulley
Hitch Pin
Clevis Pin — 3/8” x 1-3/4”
Hitch Pin
Fig.2
Fig.4
Fig.3
1
4
5
3
Trolley Shaft
Trolley Shaft
Trolley
Cable Eyelet
Loosely link together
Trolley Shaft
Chain-to-Cable Connector
Chain
2
Installing the Chain
Fig.5
Connect shaft to Trolley with “click”
Clevis Pin - 5/16” x 1-1/2”
Hitch Pin
Hitch Pin
Clevis Pin
Rail Bracket
Screwdriver
UP
Sprocket
Bearing end
Plastic end
Motor
Shaft
1
2
To Attach Sprocket
1.
Attach the Sprocket Adaptor to the Motor Shaft.
2.
Attach the Sprocket upon with the
metal bearing facing the
ceiling.
Sprocket
Adaptor
