G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
6
D-Bolt Anchor
flush against
substrate.
Nut snug against
washer. Washer
located immediately
under nut, and
compressed against
substrate. Minimum
two complete bolt
threads past nut.
Minimum 6”
Hole drilled minimum
3” from any edge or
corner. Ensure proper
hole diameter per
instructions.
Wood:
1. Wood substrate must be minimum 6” thick.
2. Pre-drill bolt installation hole. Hole must be
minimum 3” from any edge or corner. Hole
diameter must be 1/16” greater than applicable
bolt diameter.
3. Install applicable bolt through D-Bolt Anchor
and pilot hole. Always refer to bolt manufacturer’s
instructions for installation requirements.
4. Secure bolt with properly sized washer and
nut. Tighten nut until snug and ensure washer
is fully flush against substrate. Minimum two
bolt threads must be visible past nut.
5. Ensure D-Bolt Anchor is flush against substrate.
6. Attach complete and compatible PFAS to
D-Bolt Anchor.
1. Ensure all PFAS equipment is selected and deemed compatible with D-Bolt Anchor by Competent Person.
2. Make considerations for eliminating or minimizing all swing fall hazards.
3. Ensure selected substrate is compatible with D-Bolt Anchor, and is free
of any debris, rust, cracking, deformation, and hazardous materials.
Substrate must extend entire length of D-Bolt Anchor AND hook of
connecting device.
4. D-Bolt Anchor is rated for loading in any direction provided it is
installed as prescribed. Suitable for use in HLL applications.
5. Competent Person must make considerations to decrease shear
load distribution against the substrate (like overhead installations).
The use of through-bolts, bolt backer plates, or adhesive bolts are
possible methods of eliminating risk of pullout.
Installation:
Installation must be performed under supervision of Competent Person. Refer to substrate-specific section for
applicable installation requirements. D-Bolt Anchors are reusable. ALWAYS use new fastener for each new
installation application.
Summary of Contents for 00370
Page 2: ......
