Guangzhou Yingfeng Lighting Equipment Co.,Ltd
www.yf-light.com
3
11. Effect：Can transfer from beam into atomization effect
12. Panel
Control：Touch screen control and Manual control
13. Signal Control：DMX512 international standard signal
14.
Safety protection: when the machine is overheating or the system malfunctioning it will
automatically cut off power supply.
4
、
Installation
1. Before install, please make sure the power supply is the same as the product identified.
2. The cable connecting to the main power supply must meet the requirements, should not overload.
3. The installation must be done by professional person, fixed the light safely and reliable, and transferred
to appropriate irradiation angle.
4. Please ensure that the draft fan and exhaust channel is not blocked
5. At the bottom of the moving head light with insurance line connection hole, based on safety reasons,
please use the insurance rope which can withstand ten times the weight of the Moving head through the
insurance line connection hole for auxiliary lifting.
6. When install this equipment , please ensure that at least 1.5 meters range no extreme inflammable and
explosive items(ornaments, etc.) ensure the moving head light and the wall interval twenty centimeters of
above.
7. This product can be fixed hanging installation and put on the floor to use.
8. Based on the safety, please make sure the earth wire grounded.
9.The Pan and Tilt of this product was locked when packing, please ensure it was unlocked before the
power on.
5
、
Installation and change of the Lamp
1. In order to prolong the life of the moving head light as far as possible, please choose the same type of
lamp for it.
2. First of all to unscrew the four screws on the back cover of the moving head light, then open the back
cover, pinch the ceramic holder of the bulb and anti-clockwise rotation 90°
，
take out the lamp.
3. Open the bulb packing carefully, take out the new lamp, pinch lamp ceramic holder , insert the lamp
holder and 90°clockwise rotation
6
、
The connecting of the signal cable
Connected the XLR control cable from the DMX controller’s outlet to the first moving head light’s input
port , and connected from the first light’s DMX outlet to the second light’s DMX input port, repeating the
process, until all the lights are of connection. Then connected the accompanied circuit plug to the last
light’s signal output port, the connection finished, as shown in figure:
