Issue 07/2011
Page 60
Bu
ilt
-in g
en
er
at
or
s w
ith s
w
itch c
ab
in
et f
or p
er
m
an
en
tly i
ns
ta
lle
d p
ow
er g
en
er
at
io
n s
ys
te
m
s ≥ 1
2 k
VA i
n fi
re e
ng
in
es
Operation
Working safely with electrical devices
5.3
Working safely with electrical devices
Follow the following operating instructions to work safely with electrical
devices.
Pay attention to the safety instructions for operation in section 5.1,
Danger
Risk of accident and injury
y
There are risks associated with working with power
generation systems and electrical equipment.
►
Only qualified, specially trained personnel are allowed to
carry out work on electrical installations.
►
Before any work on electrical equipment, read the safety
instructions in section 5.1, page 56 and follow them.
►
Read the following operating instructions and follow them.
y
Devices which caused a shutdown by the insulation monitor and the
“INSULATION FAULT” error indication, must not be operated from other
power generation systems that have no insulation monitoring or from the
public electricity supply network. Immediately put devices with insulation
faults out of service and replace them or have them repaired by the device
manufacturer or an authorised electrician company.
y
Do not connect devices unless they are in a fully-functional and safe
condition. The units and plug connectors must be clean and dry.
Warning
Risk of accident
y
Devices which start up in an uncontrolled fashion can put
persons at risk or injury them or cause damage or themselves
be damaged.
►
Switch off all devices before you connect them to the power
generation system.
Summary of Contents for DWG (BL) 13/7-2 ZE
Page 87: ...Page 87 Issue 07 2011...
