1
IMPORTANT SAFETY INSTRUCTIONS
Because automatic gate operators produce high levels of force, consumers need to know the potential hazards associated with
improperly designed, installed, and maintained automated gate operator systems.
Keep in mind that the gate operator is
just one component of the total gate operating system
. Each component must work in unison to provide the consumer with
convenience, security, and safety.
This manual contains various safety precautions and warnings for the consumer. Because there are many possible
applications of the gate operator, the safety precautions and warnings contained in this manual cannot be completely
exhaustive in nature. They do, however, provide an overview of the safe design, installation, and use of this product.
CAREFULLY READ AND FOLLOW ALL SAFETY PRECAUTIONS, WARNINGS, AND INSTALLATION
INSTRUCTIONS TO ENSURE THE SAFE SYSTEM DESIGN, INSTALLATION, AND USE OF THIS PRODUCT.
Precautions and warnings in this manual are identified with this
warning symbol. The symbol identifies conditions
that can result in damage to the operator or its components, serious injury, or death.
Because GTO automatic gate operators are
only
part
of the total gate operating system, it is the responsibility of the
consumer to ensure that the total system is safe for its intended use.
Disconnecting the operator
1. Turn operator power switch
OFF
.
2. Remove hairpin clip, clevis pin, and bushing
from the front mounting point.
3. Remove the operator from the mount.
The gate can be opened and closed manually
when the operator is disconnected.
NOTE:
Substitute a
Pin Lock (FM345)
for the clevis pin on
the front mount only of the gate
operator
to prevent unauthorized
removal of the
operator
from the gate (
see Accessory Catalog).
To Manually Open and Close the
Gate, Follow the Procedure Below:
CAUTION: The gate will move freely and uncontrolled when the gate operator is
removed from the gate. ONLY disconnect the operator when the operator power
switch is OFF and the gate is NOT moving.
Clevis Pin
Hairpin Clip
Gate Bracket
Front or Rear Mount
Bushing
CAUTION:
Because the GTO/PRO gate operator is
battery powered, disconnect the
operator
ONLY when the
power switch on the
operator
is turned OFF. Unplugging
the transformer does not turn power to the
operator
OFF.
IMPORTANT:
NEVER allow operator arm to hang by
the front mount - it will break from the arm weight.
