GTO Digital Controlled Gate Opener Light Kit, Manual

Page: 10 / 12

8
ON/OFF
12 Volt DC
AUTOMOTIVE
or MARINE
TYPE BATTERY
x2
DE
LA
Y TIMER
0
60
Connecting Light Kit to Mighty Mule 350 and GTO/PRO-SW1500 Openers
NOTE:
When the Light Kit is used with the Mighty Mule 350 or the GTO/PRO-SW1500, a weatherproof junc-
tion box (not included) must be used to house the Light Kit control board and Photocell. Weatherproof junction
boxes can be found at your local hardware or electrical supply stores.
BLACK operator BLACK BLACK
power wire
Wires from
Lights
Photocell
Light Kit Control Board
Wire Nuts
Wire Splicing Locks
BLACK Light Kit
wire to
Negative
Battery Terminal
Mighty Mule FM350 and GTO/PRO SW2500 Gate Opener Control Boards
BLUE Wires connect to BLUE BLUE
opener power wires
RED Light Kit wire
to
Positive
Battery
Terminal
BLUE Light Kit wires
to
RED
and
BLACK
opener power wires
WHITE Wires connect to WHITE WHITE
Photocell
x2
RED operator
power wire
RED and BLACK Light Kit BLACK BLACK
wires connect to battery
Weatherproof Junction Box
(not included)
1. Connect the RED and BLACK wires from the Light Kit control board to a section of 16 gauge low voltage
wire long enough to run from the junction box to the gate opener battery. Connect the RED wire to the POSI-
TIVE battery terminal and the BLACK wire to the NEGATIVE battery terminal.
See diagram below .
2. Connect the BLUE Light Kit wires to two sections of 16 gauge low voltage wire (two BLUE wires to each
section) using wire nuts (provided). Connect the other ends of the 16 gauge wires to the opener power wires on
the gate opener control board (one to the RED wire and one to the BLACK wire), using the wire splicing locks
(provided).
See diagram below and Figure 16 .
4. Connect the WHITE wires from the photocell to the WHITE wires from the Control Board Plug using the wire
nuts provided. See diagram below .