Procedure
1. Remove the bolts (A) and the washers
(B).
2. Start the machine and let it run idle.
.
3. Do not put any material in the input.
4. Tilt the output (C) until the locking key
is removed from the safety lock switch
(D).
Caution: Make sure that
the machine fully stops.
5. The test is successful if the machine
stops.
6. Tilt the output back.
7. Install the bolts and washers.
6.4
Do a detection test of the input
Warning:
Use the bumper support to make sure that the machine stays balanced during
the test.
B
A
D
C
Preventive maintenance
28
D09-CC13S20-11
