LITERATURE
DIMENSIONS
ARE
FOR
GENERAL
REFERENCE USE ONLY. INSTALLATION DIMENSIONS
SHOULD BE TAKEN DIRECTLY FROM THE UNIT.
GARFIELD
RECOMMENDS
THAT
A
LICENSED
CONTRACTOR
AND/OR
ELECTRICIAN
PLAN
&
PERFORM INSTALLATION.
Wall -
The wall must be strong enough to support the arm
assembly and dryer head.
Recommended Height -
Wall bracket should be mounted
72.5” – 76.5” from the finish floor line.
Electrical Source -
An electrical source with proper power
should be prepared and located within 19” of the wall bracket.
WALL PLATE AND BRACKET SUPPORT A LARGE
LOAD. BE SURE THAT WALL PLATE BRACKET ARE
SECURELY INSTALLED.
1. Using the wall plate as a template,
drill 2 holes on the wall. You may
need a leveler to ensure that the 2
holes are straight and aligned.
2. Insert the anchor bolts (supplied).
3. Hammer the anchor pins into the anchor bolts.
4. Insert the square neck flat head bolts to the wall
plate (Fig. 4a). Attach the wall plate to the wall on
anchor bolts and affix with nuts.
5. Attach the bracket over the square neck bolts and
tighten with plastic washers, steel washers and nuts.
(Fig. 5).
6. Place the steel washer onto the stem of the wall
bracket and mount the arm assembly onto the stem
(Fig. 6).
7. Remove the hook by loosening the screw.
8. Insert the contact post into the tip of the arm
assembly. Match the grooves on the contact post to
the hook (Fig. 7).
9. Reinstall the hook into the slot and tighten firmly.
10. Attach the metal cover over the hook (Fig. 8)
11. Remove the stopper.
CAUTION: DO NOT remove stopper until machine
head is fully mounted. Strong spring tension may
cause serious injury during assembly / disassembly.
12. Connect the power cable to the electrical source.
Height Restriction
(Fig. 9) If the machine head hits the
ceiling, remove metal cover and adjust the nut as shown.
Tension
If the machine head drifts to the left or the right,
remove arm cover (Fig. 10). Using an allen wrench, adjust
nut (Fig. 11).
“+” Increase: Turn clockwise
“-” Decrease: Turn counter clockwise
WALL MOUNT: PRE-INSTALLATION
WALL PLATE & BRACKET
ARM ASSEMBLY & MACHINE HEAD
ADJUSTMENT
