Fig. 3
3)
The module can be mounted on a guide rail as
shown on Fig 4.
4)
The module can also be installed in the
enclosure by 4 mounting screws as shown in
Fig.5.
Fig. 4
Fig. 5
Application
The module connects with fire control devices which
are activated by the FACP.
The address and operating mode of the module can
be programmed by a programmer in field. Please refer
to
P-9910B Hand Held Programmer Installation and
Operation Manual
for details.
Programming Parameters
：
In standby state of the programmer, press
Fn
and then
number 3, “—“will be popped up on the screen to
indicate it is in programming mode. Write a parameter
and then pressing “Program”, a “P” will show on the
screen meaning the parameter is programmed.
Press Fn and then number 3, input checking methods
can be set.
Parameters Setting
Input
1
Self-answering
2
normally-closed
Any other
numbers(Default)
normally-open
Pressing Fn and 4 can set the number of addresses.
Parameters Setting
points
2
occupies two addresses,
one for the input and one
for output
Any other
numbers(Default)
one address for both input
and output
Note: “Normally-closed” opinion can only be used for
trouble circuit, or Class E non-fire, non-emergency
input, e.g. door status sensor.
Connection of the module to field devices with
normally open dry contact is shown in Fig. 6(line
detection is provided by the controlled device).
Connection of the module to devices controlled
by 24VDC is shown in Fig.7 (line detection is
provided by the controlled equipment).
NC
I
Z2
Z1
COM
Z1
G
NO
Z2
I
Z2
Z1
COM
Z1
G
NO
Z2
4.7kΩ
4.7kΩ
a b
NC
Feedback
Controlled Device
Control
Input
Feedback
Control
Input
Controlled Device
DI-M9301
DI-M9301
F
AC
P
F
AC
P
Fig. 6
Z2
NO
G
Z1
COM
+24V
GND
Z1
Z2
I
a
b
4.7kΩ
DI-M9301
NC
Z2
NO
G
Z1
COM
+24V
GND
Z1
Z2
I
4.7kΩ
NC
Controlled Device
Controlled Device
DI-M9301
Power
FACP
Power
FACP
Fig. 7
30310199 Issue 1.06
