GST8903
Intelligent Graphic Repeater Panel
Installation and Operation Manual
The Intelligent Solution
Page 6
second and third digits represent zone number where the device is, the
last three digits represent device number. For other models, the first three
digits represent zone number where the detector locates and the last
three digits represent the device number. If the device number is 255, all
the devices with the same zone number can be displayed.) Press
Program
, if the programming succeeds, a “P” will be shown on the screen;
if the programming fails, an “E” will be shown on the screen.
b) To change the LED number: You can directly input the required LED
number. Pressing the function key, the screen shows “LED number L “.
Pressing the
Function
key again, the screen shows “0”. Input the required
user number, press
Program
. If the programming succeeds, P will be
shown on the screen, if the programming fails, E will be shown on the
screen.
Note:
(1) If the first input LED number is written in when changing the LED
number, this operation will delete the original LED number and
user code, and write in the new LED number and user code, so
that this operation can be used to modify an incorrect LED
number and user code. At most 100 LED numbers can be written
in, the screen will show “PPPP” when all numbers have been
finished.
(2) Every fire alarm signal can only light one LED of GST8903, even
if all LED are defined the same. It cannot be defined to display by
device and by zone at the same time.
5.4.4 After programming LED number and user code are written successfully,
the “L and the next light number” will be shown on the screen. If it is the
same as the required LED number, you can start from section 5.4.3; if
not, press the “Clear” key, you can enter repeater panel mode of the
programmer again to write in new LED number and user code.
5.5 Read-out of the LEDs number and user code.
5.5.1 Enter into repeater panel mode of the programmer, “0” is on the
screen.
5.5.2 Input the serial number of LED; press the
Test
key, “E light number” will
be shown on the screen.
5.5.3 Press
Up
. It will show the high of four digits and the low of two digits in
turn of the user code.
5.5.4 Press
Test
repeatedly, then the LED numbers will be displayed in
sequence: next LED number and user code …the last LED number
and user code, H and total LED numbers, and then the first LED
number and user code….
E-MAIL: [email protected]
