- 8 -
PHIS 1000 S
3
a
ssembly
3.1 i
nstalling
the
Casset te
– Ensure the head-end station is mounted so it will not be able to vibrate.
Avoid, for example, mounting the head-end station onto a lift shaft or any
other wall or floor construction that vibrates in a similar way.
– Before installing or changing a cassette unplug the power cable from the
mains power socket.
• Remove the fastening screws
1
of an unoccupied slot from the bracket of
the head-end station.
• Insert the cassette in this slot and push it into the housing.
• Align the cassette and apply slight pressure to connect it to the connections
of the board and the RF bus bar.
• Fasten the cassette with the screws
1
.
• If you need the DiSEqC
TM
control the input signal must not be fed via the
input distributor. Insert the cable termi nals together with the contact washers
in corresponding open ings (knock-outs). Therefore observe the EMC regula-
tions on page 9.
1
1
