P a ge 4
How to Programme the Mobile Number
After inserting the simcard into the GSM module, turn the unit on and wait until you see
the
GREEN
LED come on. This indicates that the module has a signal and the unit is
ready to be used.
Please Note - To avoid confusion we have colour coded the
hash
(
#
) and the
equals
(
=
)
symbols. Furthermore, where it indicates a phone number this should be
your number or the numbers you wish the unit to contact.
To programme your phone numbers into the unit you will need to send the text message
as follows:
Example: (
hash
) (PH) (
equals
) (phone number) (
hash
)
#
PH1
=
07123456789
#
Then send this to the unit simcard number.
#
PH2
=
07753651298
#
Then send this to the unit simcard number.
The unit will reply number stored
When the unit is triggered it will send an alarm message to thiese numbers
How to programme the SMS Text Message
You can now change the alarm default message from “IR??” To one of your choice.
To change the message send the text command as follows
#
IR01
=
YOUR MESSAGE
#
Default message is IR01
#
IR02
=
YOUR MESSAGE
#
Default message is IR02
The detector will reply with the text message - “MESSAGE STORED”
By changing position 01 to 20, you can name all 20 individually paired sensors.
PLEASE NOTE
Your can only use a maximum of 30 characters including spaces for your customised
message.
How to Setup Call Alerts
The auto dialler can be programmed to send you a telephone call after each text alarm
has been sent.
You will receive approximately three ring tones. The unit will then hang up automatically.
This is to prevent call charges being incurred.
To set call alerts to ON please send the text message
#
CALL
=
ON
#
The unit will reply back “call on”
To disarm call alerts please send the text message.
#
CALL
=
OFF
#
You will then revert back to the default text message only alert
