Inputs
As you can see in the circuit diagram above the inputs can be activated by pulling input 1,
2 & 3 to ground. Alternatively, input 4 can be triggered by pulling to ground or if the link is
applied using a positive trigger.
Relay Output - Volt Free Contact
The relay has common, normally open and normally closed contacts which are capable of
8 Amp loads. This is suitable for turning on or off electrical equipment. Alternatively, it
can be used for resetting your alarm system.
The relay can be manually activated by text message commands or it can be set to pulse
for 20 seconds when an input has been activated - Please refer to page 6
NOTE
- For alarm panel installations please make sure you supply a 9-24 volts DC from
the battery terminals using a 2 amp fuse.
Page 9
www.gsm-activate.co.uk
- 01273462380 - [email protected]