Page 7 of 8
Model:
MPPT10HV
Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
400W Solar Charger
Maximum Power Point Tracker
Operating Instructions
Please read these instructions before use
Wiring The Remote Alarm:
The remote alarm is a normally low, 5V digital signal that goes high when the battery voltage drops below
0.9 of nominal voltage, the LVD disconnects or over temperature trips. It has a 5mA source capability and
can be used to remotely monitor system status.
Wiring With Load Remote Control:
This option enables the remote load connection and disconnection via the load remote control,
GREY wire. When the GREY wire is grounded the load is disconnected otherwise the load is
connected. To configure this mode the ORANGE wire must be grounded. This option overrides the
LVD or DDS function but has the same load limitations of 10A continuous or 20A transient.
Grey
LOAD
Orange
Blue
MPPT10HV R3
Buzzer, LED
PC I/O 5V 5mA
+
-
Yellow
Green
Please ensure that your MPPT has been correctly configured for your application. Refer
to the Settings and Configurations section for more information.
Green
