22
PNEG-1583
10" Commercial Replacement Drive Kit
4. Installation
2. Install the drive pulley onto motor shaft making sure that it is aligned with the flight pulley. It may
be necessary to move spacers to gain shaft alignment. Use the 3/4'' flat washer where the 1/2''
spacers cannot be used.
Figure 4U
Install the Belts
1. Place the belts onto the pulleys.
2. First, screw the lower motor mount adjustment nut upward, raising the motor mount plate and
putting tension on the belts.
3. Once the desired tension is reached, tighten the upper motor mount adjustment nut down onto the
motor plate locking it into place.