GSi Cumberland PNEG-1333, Installation And Owner'S Manual

Page: 20 / 68

4. Assembly
20 PNEG-1333 Turkey Poult Feeder System
Drive Unit/End Control Pan Assembly
1. Remove the bottom and top plate assembly from the control pan. Remove the anchor plate from the
control pan unit and bolt it to the drive unit as shown in Figure 4N . Note the orientation of the anchor
plate and make sure the bevels are on the bottom side of the drive unit.
2. Use the four (4) bolts to assemble the anchor plate back onto the control pan assembly as shown in
Figure 4O . There may be some assembly and adjustment to the control unit required. Refer to the
pan feeder assembly on Page 14 for instructions.
Figure 4N
Figure 4O