GSI Group 890-00584, Installation And Configuration Manual

Page: 90 / 120

Chapter 13: Maintenance
127–00033 Fuse 500MA slowblow
5X20MM 250V F31-
F32 Bel Fuse 5HT 500-R
127–00034 Fuse 2A slowblow
5X20MM 250V F33-
F34 Bel Fuse 5HT 2-R
Replacing a Fuse
Before You Begin
Only service personnel is authorized to replace a fuse.
CAUTION
Before servicing the system, disconnect the main sector voltage and disconnect the
battery wires from the battery.
WARNING
Wear appropriate grounding devices such as an anti-static wristband to service the
system.
1. Open the circuit of the main sector voltage.
2. Disconnect the red wire from the positive battery terminal.
3. Isolate the source of the fault and correct it.
4. Install the red wire to the positive battery terminal if the replacement is completed.
5. Close the circuit of the main sector voltage.
Replacing the Battery
At some point the battery will need to be changed. Properly doing so ensures the system functions
properly.
Before You Begin
WARNING
Installation must only be performed by qualified service personnel. Comply with local
and national safety codes.
1. Open the circuit of the main sector voltage
2. Disconnect the red wire from the positive battery terminal.
3. Disconnect the black wire from the negative battery terminal.
4. Remove the battery from the battery box
5. Install the new battery in the battery box. Ensure that the new battery is fastened correctly in the bat-
tery box.
6. Install the black wire to the negative battery terminal.
7. Install the red wire to the positive battery terminal.
8. Close the circuit of the main sector voltage to reactivate the controller.
90 895-00677 Agri Alert 128 Touch