H49.0.02.6C-04
Operating Manual GMH 3750
Page 9
5.2 „Func-CYCL“: Automatic Recording With Selectable Logger-Cycle-Time
The Logger-Cycle-Time is selectable (p.r.t. Configuration). For example „CYCL“ = 1:00: A measuring is recorded after
each 60 seconds.
Max. number of measurings:
16384
Cycle time:
0:01...60:00 (minutes:seconds, min 1s, max 1h), selectable in the configuration
A measuring contains:
- current measuring value at the time of recording
Starting a recording:
By pressing "Store" (key 6) for 2 seconds the recording will be initiated. After that the display shows ‘St.XXXXX‘ for a
short time whenever a measuring is recorded. XXXXX is the number of the measuring 1..16384.
If the logger memory is full, the display will show:
The recording automatically will be stopped.
Stopping the recording manually:
By pressing "Store" (key 6) the recording can be stopped manually. Then the following choice appears:
The selection can be made by
5
(key 2) and
6
(key 5). "Quit" (key 6) enters the choice.
Note:
If you try to switch off the instrument in the cyclic recording operation You will be
asked once again if the recording should be stopped.
The device can only be switched off after the recording has been stopped!
The Auto-Power-Off-function is deactivated during recording!
Clear Recordings:
When „Store“ is pressed for 2 seconds, the choice for clearing the logger memory will be displayed:
The selection can be made by
5
(key 2) and
6
(key 5). "Quit" (key 6) enters the choice.
Stop the
recording
Do not stop the
recording
Clear all
recordings
Clear nothing
(cancel menu)
