16
Operation Instructions
Phase 3 - Enrolling Door Controls
Step Description
All Door Controls should be installed at this point and powered up.
1. All Door Controls must be defaulted before joining a network.
Note: Door Controls will be shipped with their factory default settings.
Enter Engineer mode on each
Keypad Door Control
in the following way
A. Press X followed by 6666
B. Enter 55 –to default
C. Press the tick to confirm – the keypad will now go through the
process of defaulting itself.
D. When this process has complete hit the X button to leave engineer
mode and to put the keypad control in the ‘Scan Mode’ – the Red Led
on the Door Control will now be in flicker mode as an indication.
E. Repeat the process for all keypad Door Controls
Enter Engineer mode on each
Wi-Bio
Door Control
in the following way
A. Enter 6666
B. Enter 55 –to default
C. Scan Finger to confirm – the Door Control will now go through the
process of defaulting itself.
D. When this process has complete Scan Finger again to leave engineer
mode and to put the Door Control in the ‘Scan Mode’ – the Red Led
on the Door Control will now be in flicker mode as an indication.
E. Repeat the process for all Wi-Bio Door Controls
Enter Engineer mode on each
Prox Only Door Control
in the following way
A. Add a programming card to the Door Control by presenting a card
twice on power-up. The security wing must be removed first!
B. Present this new programming card to enter Engineer mode.
C. Present the programming card again to select “Default mode”.
D. Present any other card once to default the Door Control.
E. When this process has complete the Door Control will be in the ‘Scan
Mode’ – the Red Led on the Door Control will now be in flicker mode
as an indication.
17
Operation Instructions
Phase 3 - Enrolling Door Controls
Note:
For Wired 485 Door Controls, right click on the Controller on the
right hand side of the application and select ‘Manually Assign Address’
from the drop down menu.
Once all new Door Controls are found by the Controller they will all
‘beep’ with the number of the next available address/door position on the
Controller.
e.g. if door 2 is the next available address then all Door Controls will beep
at the same time with 2 beeps. This is basically saying that any door can
be assigned to this address – it’s up to the installer to decide which one.
Also – you will notice that the Key back light of the keypad Door Controls
will be illuminated with the next available address as well.
i.e. Key 2 will be illuminated for this example.
3. Go to the Door control that you want to make door 2 on the network
system (it should be beeping 2 times). Press any key on this keypad and
the system will automatically assign this door control to door 2 location on
the system. Present a card if the Door Control is Prox Only.
Note: All other Door Controls will now start beeping with the next
available address i.e. ‘3 beeps’ in this instance and so on every time you
enroll a new Door Control. The Key back light will also correspond to
each address as the system fills up.
Step Description
2. The controller is now ready to allow Door Controls to enroll onto the
Network – click the ‘Allow Doors to join this Controllers Network’ on
the ‘Controllers’ tab to start the controller scanning for new doors that do
not already have an address – only DoorControls without an address can
enroll – this will avoid other networks and Door Controls in the same
building on a different network becoming part of this new network!