Grundig WTR 3000 BT, Manual

Page: 5 / 95

5­ ­ ENGLISH
SAFETY­AND­INFORMATION
­----------------------------------------------------------------
7
This device is designed for the playback of au-
dio signals.
Any other use is expressly prohibited.
7
Make sure the device is protected from drip-
ping or splashing water.
7
Do not place any vessels such as vases on the
device. These may be knocked over and spill
fluid on the electrical components, thus present-
ing a safety risk.
7
Do not place any naked flames such as candles
on the device.
7
Only use the device in a moderate climate.
7
Ensure that the device is adequately ventilated
by placing it at least 10 cm from any other ob-
ject. Do not cover the device with newspapers,
table cloths, curtains, etc.
7
If malfunctions occur due to static electricity
charges or fast transient (burst), reset the de-
vice. To do this, pull out the power plug and
connect it again after a few seconds.
7
When deciding where to place the device,
please note that furniture surfaces are covered
by various types of varnish and plastic, most of
which contain chemical additives. These addi-
tives can corrode the device supports, leaving
residues on the furniture surfaces which can be
difficult or impossible to remove.
7
Do not use any cleaning agent, as this may
damage the casing. Clean the device with a
clean, dry cloth.
7
Never open the device casing. The manufac-
turer will not accept any liability for damage
resulting from improper handling.
7
Make sure the power plug is freely accessible.
7
Note, prolonged listening at loud vol-
umes with the earphones can dam-
age your hearing.
RF­Exposure­Warning
7
This equipment must be installed and operated
in acordance with provided manual.
The device comprised a built-in antenna, and
must not be co-located or operating in conjunc-
tion with any other antenna or transmitter.
7
The only way to completely disconnect the
device from the mains is to unplug the mains
cable.
Technical­data
This device is noise-suppressed
according to the applicable EU
directives. This product fulfils the
European directives 2014/53/
EU, 2009/125/EC and 2011/65/EU.
You can find the CE declaration of conformity for
the device in the form of a pdf file on the Grundig
Homepage www.grundig.com/downloads/doc.
The type plate is located on the back side of the
device.
Power­supply:­
230 V~, 50/60 Hz
Max.­power­consumtion:
Operating < 20 W, Stand-by < 1 W
Output:­
DIN 45324, 10% THD
­
5 W
Frequency­band:­
FM 87.5 ...108.0 MHz
Dimension­and­weight:­
B x H x T 259 x 136 x165 mm
Weight approx. 2.52 kg
Frequency­bands:­ 2402 - 2480 MHz
Maximum­radio-frequency­power­trans-
mitted:
< 20 dBm
The power consumption of the product in net-
worked standby (only one bluetooth port):
0.785W with clock display.
Technical and design modifications reserved.