12 ENGLISH
OPERATION _______________________________
Preparation
1
Remove all packaging and sticker materials
and dispose of them according to the
applicable legal regulation.
2
Before using of the appliance for first time,
clean all parts which come into contact with
water carefully.
(See the “Cleaning and care” section).
3
Completely roll out the power cord
L
from
the power cord storage
K
on the bottom of
the base
J
. Pass the power cord through the
slot on the base.
4
Fill the water tank
G
with water.
5
Set the kettle on its base
J
. Make sure that
the kettle is sitting in an upright position and
that it is sitting on the base correctly and in a
stable position.
6
Pour out the hot water and rinse the kettle
with water. This will remove any remaining
manufacturing residues from the inside of the
water tank
G
.
7
Clean kettle well before initial use and discard
water of first two boiling cycles.
Operation
1
Push the lid release button
D
on the kettle to
open the lid
A
.
– The lid
A
opens automatically.
2
Fill the water tank
G
with water.
Note
■
Do not place the water tank
G
on the base
J
while filling it with water.
■
Never fill the water tank
G
above the
maximum level indicator or below the
minimum level indicator.
3
Close the lid
A
until it clicks into place.
4
Place the water tank
G
on the base
J
. Make
sure that it is sitting in an upright and stable
position.
5
Insert the plug into the wall socket.
6
Press down On/Off switch
I
.
– Power on indicator
H
illuminates and
heating process begins.
Note
■
Lid
A
should always be closed during the
heating process; otherwise the kettle will not
switch off automatically.
7
After a few minutes, the water will start to boil.
The kettle switches off automatically and On/
Off switch
I
moves upwards.
- Power on indicator
H
goes off
Note
■
If you want to stop the heating manually, push
the On/Off switch
I
upwards. Power on
indicator
H
goes off.
8
Disconnect the plug from the wall socket.
9
Take the water tank
G
from the base
J
. Only
hold it by the handle
E
.
Caution
■
Do not open the lid
A
as hot water could
splash out. Make sure that no water splashes
onto the base
J
.
10
Pour the water from the spout
B
to the cup
or glass you want to use.
Note
■
If you want to continue the heating process,
repeat the procedure from 1 to 10.
■
Let the kettle cool down between each heating
process.
Hints and Tips
■
The kettle is equipped with a filter
C
which
filters out limestone and other residues when
the water is being poured out.
■
Use softened or filtered water to prevent lime
build-up.
Summary of Contents for WK5040
Page 1: ...WK 5040 FR DE HR EN PL TR ES KETTLE...
Page 2: ......
