Grundig UMS 2010, User Manual, Page: 17 / 23

17­
ENGLISH
TAPE­MODE­
­-----------------------------------------------------------------------------------------------------------------------------
Selecting­the­tape­input­source
1 Press » SOURCE « on the hi-fi system repeat-
edly or press » CASS « on the remote control.
– Display: » CASS «.
Tape­playback
1
Open the front flap which is marked with
» OPEN « on the front panel.
2
Press »
7
J
« to open the tape compartment.
3 Insert a tape in the compartment with the open
side facing downwards and the full reel on the
left side and close the compartment.
4­ Close the tape compartment.
5
Press »
8
« to start playback.
– The button is automatically released at the
end of the tape, except if pause function has
been activated.
6
To pause playback press »
II
« and resume
playback by pressing » II « again.
7
End playback with »
7
J
«.
Notes
7
The source cannot be changed while play-
ing or recording a tape.
7
If you switch out the device during playback,
you will see »
REL
« in the display. This inform
you, end the playback with »
7
J
«, then
switch off the device.
Fast­forward­and­reverse­search
1
In stop mode, press »
3
« or »
4
«.
– »
3
« rewinds to the beginning, »
4
«
fast forwards to the end.
Recording­onto­tape
Erase­protection
Each new recording writes over the previous re-
cording.
You can protect your recordings against inad-
vertent deletion by breaking the protection tab in
the opening in the spine of the tape.
Purchased recordings on music tapes are al-
ready protected against accidental deletion.
If you wish to record on a protected tape, seal
the opening with adhesive tape.
Notes:
7
Only use NORMAL-type tapes (IEC I) for
recording. CHROME (IEC II) or METAL (IEC
IV) tapes are not suitable.
7
The Ultra Bass System does not affect re-
cording.