Grundig TA 8680, Manual

Page: 19 / 108

19 ENGLISH
Preparation
1
Remove all packaging and sticker materials
and dispose of them according to the applica-
ble local regulations.
2 Before using the appliance for the first time,
clean the appliance (See the “Cleaning and
care” section).
3 Make sure that the appliance is in an upright
position and on a stable, flat, clean, dry and
nonslip surface.
Note
7
When using the appliance for the first time,
smoke can develop due to production residues.
However, this does not mean that the appliance
is defective. The first time you switch it on use
the appliance as you normally would but with-
out bread. It is recommended to use the medium
setting of the +/- digital heat control
J
. Ensure
sufficient room ventilation.
Toasting
1 Insert the power plug into the wall socket.
2 Place bread slices into the bread slot
B
.
3
Use the+/- digital heat control
J
to select the
desired degree of browning between 1 and 7.
Notes
7
Sliding the +/- digital heat control
J
to 1 will
give the lightest degree of browning and slid-
ing it to 7 the darkest.
7
The browning degree can vary depending on
the type of bread.
7
When toasting several slices of bread consecu-
tively, the toaster will become hotter and thus the
bread will gradually become darker. Therefore
select an appropriate browning degree. Let the
toaster cool down after each toasting process
for a minimum of 30 seconds.
7
The degree of browning for a single slice will
be darker than for two slices, although the +/-
digital heat control
J
is set to the same level.
4
Press the start lever
K
until it automatically
snaps into place.
– The toasting process begins. The indicator
light of the stop button
H
illuminates during
the toasting process.
Notes
7
If the power plug is not connected into the wall
socket, the start lever
K
does not snap into
place.
7
The degree of browning can also be adjusted
during the toasting process with +/- digital heat
control
J
.
5 The appliance automatically switches off as
soon as the set degree of browning has been
reached.
– The start lever
K
springs back up and the
stop button
H
light disappears. The toast
slices are pushed upwards and can be taken
out of the toaster.
Notes
7
To cancel the toasting process before it has fin-
ished, press the stop button H . The start lever
K
springs back up and the toast slices can be taken
out of the toaster.
7
After the start lever
K
springs back up, you can
use the high-lift function by pushing the start lever
K
upwards.
Caution
7
Be very careful when taking the toast slices out of
the toaster as the metal parts of the toaster and
also the bread can become very hot.
6 Disconnect the appliance from the wall socket.
Note
7
If toast slices get stuck in the toaster, switch the
toaster off immediately by pressing the stop but-
ton
H
. Pull the power plug out of the wall socket.
Let the toaster cool down completely. Carefully
try to take the bread out of the toaster without
damaging the sensitive heating elements and
other parts. Do not use any electroconductive
objects to remove the bread from the toaster.
OPERATION ______________________________