
33
ENGLISH
Troubleshooting
If a fault occurs, first refer to this information be-
fore you take the device for repair.
If you are unable to rectify the fault using the in-
formation given here, contact your local dealer or
service specialist.
Under no circumstances should you attempt to
repair the radio recorder yourself, as this would
invalidate the guarantee.
INFORMATION
---------------------------------------------------------------------------------------------------------------------
PROBLEM
POSSIBLE
REMEDY
GENERAL
INFORMATION
No sound.
Volume is too low, headphones
are connected, batteries are flat,
batteries are incorrectly inserted.
Power cord incorrectly con-
nected
Static electrical discharge
Increase volume, disconnect the
headphones.
Insert new batteries.
Insert batteries correctly.
Connect power cord correctly.
The radio recorder does
not react when the buttons
are pressed.
Static electrical discharge.
Switch off the device, disconnect
the mains cable and plug it in
again after a few seconds.
Remove any batteries.
RADIO
Poor radio reception.
Weak radio antenna signal.
Interference from electrical
devices such as televisions, video
recorders, computers, neon
lamps etc.
VHF (FM): tilt and turn the telescop-
ic antenna.
MW: turn the whole device.
Keep the radio recorder away
from electrical devices.
CD
Playback will not start.
The CD is damaged or dirty.
Replace or clean the CD.
The CD player skips tracks. A stored playlist is being played.
The RANDOM function is
activated.
Switch to normal playback or
delete.
Switch off the RANDOM function.
CD-Rs or CD-RWs are
not being played back,
or being played back
incorrectly
The CD is faulty or the software
or hardware settings were incor-
rect during burning.
Check the components of your
CD burner / burner software or
change the CD you are using.
TAPE
Poor cassette playback
sound quality.
Dust and dirt on magnetic heads,
capstans or idlers.
Clean the magnetic heads, cap-
stan and idler.
No cassette recording.
Recording protection tab has
been broken off.
Cover the opening with adhesive
tape.