Grundig RCD 1445 USB, Manual

Page: 20 / 162

ENGLISH
20
Mains operation
Note:
7
Check that the mains voltage on the type plate
corresponds to your local mains supply.
7
If this is not the case, contact your specialist dealer.
1 Plug the mains cable supplied into the » AC
~
«
socket on the radio recorder (back of device).
2 Plug the mains cable into the wall socket.
Caution:
7
The device is connected to the mains with the po-
wer plug. To fully disconnect the device from the
mains, pull out the plug.
7
The mains plug is used to disconnect the device. It
shall remain readily operable and should not be
obstructed during intended use.
Battery operation
1
Open the battery compartment by pressing the catch
and removing the lid.
2 Insert six batteries (6 x 1.5 V/type IEC R14/UM2/
C-size), observing the polarity marked on the lid of
the battery compartment.
POWER SUPPLY
_____________________________________________________
3 Close the battery compartment.
Notes:
7
Do not expose the batteries to extreme heat,
caused for example by direct sunlight, heaters or
fire.
7
Remove the batteries when they are flat or when
you know that the device will not be used for a
long period of time.
7
The manufacturer accepts no liability for damage
resulting from leaking batteries.
7
The batteries are switched off during mains op-
eration.
Environmental note:
7
Batteries, including those which contain no heavy
metal, may not be disposed of with household
waste. Please dispose of used batteries in an en-
vironmentally sound manner. Find out about the
legal regulations which apply in your area.
Switching the Ultra Bass System on
and off
This function boosts the bass frequencies.
1 Switch the Ultra Bass System on and off with » UBS «.
Listening with headphones
1 Connect the headphones to the » 0 « headphone
jack (ø 3.5 mm).
– This switches off the loudspeakers.
Note:
7
Excessive sound pressure from the earphones or
headphones can cause hearing loss.
Automatic shutdown
If the device is in the “Stop“ position for more than 15
minutes it automatically switches to Stand-by mode. For
further using switch on the device again.
Switching on and off
1 Switch on the device with the required input source
by moving the switch to the
»
OFF CD USB RADIO « position.
2 Move the » OFF CD USB RADIO « switch to the
» OFF « position to switch off the device.
Selecting the input source
1
Select the input source (CD, USB or RADIO) using
»
OFF CD USB RADIO
«.
Adjusting the volume
1 Adjust the volume with » VOLUME «.
GENERAL FUNCTIONS
___________________________________________