19
ENGLISH
6
Press »
TUNING
« to set the 24-hour or 12-
hour format and press
»
TIME
« to confirm.
7
Press »
TUNING
« to switch on the RDS time
synchronisation (
CT ON
) or to switch off (
CT
OFF
).
8
Press »
TIME
« to confirm the setting.
– Display: the current time and day of the
week. If the 12-hour format is selected,
»
PM
« appears during the second half of the
day.
Setting the alarm time
1
Press »
ON/OFF
« to switch off the device.
2
With the device switched off, press »
ALARM
«.
– Display: the last alarm time set.
3
Hold down »
ALARM
« until the hour flashes in
the display.
Note:
7
If you do not press any button within 6 sec-
onds, the device will quit set-up mode. Any
altered settings will be stored.
4
Press »
TUNING
« to set the hour and press
»
ALARM
« to confirm.
– Display: the minutes flash.
5
Press »
TUNING
« to set the minutes and press
»
ALARM
« to confirm.
– Display: the set alarm time.
– After a short time, the display changes to
the current time.
SETTINGS
________________________________________________________________
Disabling the buttons
1
Press and hold down »
ON/OFF
« to disable
the buttons.
– Display: »
P
«.
2
Press and hold down »
ON/OFF
« to enable
the buttons.
– Display: »
P
« disappears from the display.
Changing frequency increments
1
Use »
9 kHz 10 kHz
« (in the battery com-
partment) to change the frequency increments
(MW 9/10 kHz).
Caution:
7
Switching the frequency increments deletes
all stored settings (reset).
Setting the reception sensitiv-
ity (for SW band)
1
Set the switch »
●
DIST.
●
LOCAL
« to position
»
●
DIST.
«.
– The sensitivity is set to high, in other words,
long-range reception.
2
If the signal is too strong, and is causing distor-
tion, move the switch »
●
DIST.
●
LOCAL
« to
»
●
LOCAL
« (low sensitivity).
