Grundig GTN 38240 GCW, User Manual

Page: 10 / 36

10 / 36 EN
Dryer / User Manual
3
Installation
Refer to the nearest Authorised Service Agent
for installation of the product. To make the
product ready for use, make sure that the
electricity and water drainage systems are
appropriate by reading the information/
instructions given in the user manual before
calling the Authorised Service Agent. If
they are not, call a qualified technician and
plumber to have any necessary arrangements
carried out.
C
Preparation of the product's location
as well as the electrical, clean water
and waste water installations is under
customer's responsibility.
B
CAUTION: Installation and electrical
connections of the product must be
performed by the Authorised Service
Agent. Manufacturer shall not be
held liable for damages that may
arise from procedures carried out by
unauthorised persons.
A
CAUTION: Prior to installation,
visually check if the product has any
defects on it. If so, do not have it
installed. Damaged products cause
risks for your safety.
A
CAUTION: Let your dryer wait for 12
hours before starting to use it.
3.1 Appropriate installation
location
ƒ
Install the product on a stable and level
surface.
ƒ
Dryer is heavy. Do not move it by yourself.
ƒ
Operate your product in a well ventilated,
dust-free environment.
ƒ Do not block the air ducts in front of and
under the product with materials such as
long pile rugs, or wooden plinths.
ƒ Do not install the product behind a door
with a lock, sliding door or a hinged door
which can strike the product.
ƒ
Once the product is installed, it should
stay at the same place where its
connections have been made. When
installing the product, make sure that the
rear wall of it does not touch anywhere
(tap, socket, etc.). Also pay attention to
select an installation location which you
will not be required to change afterwards.
ƒ Place the product at least 1.5 cm away
from the edges of other furniture.
B
CAUTION:
Do not place the
product on top of the power cord.
3.2 Removing the
transportation safety assembly
A
CAUTION: Remove the
transportation safety assembly before
using the product for the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it
from its section marked with
XX XX .
3. Pull the nylon towards yourself and
remove the transportation safety
assembly.
A
CAUTION:
Check that no part of
the transportation safety assembly
remains inside the drum.