Grundig GSNE 107E20FN, User Manual

Page: 7 / 116

8
to make sure that the electricity
and water installations are
suitable. If they are not, call
a qualified electrician and
plumber to have the necessary
arrangements made. Otherwise,
there is the risk of electric
shock, fire, problems with the
product, or injury!
•
Prior to installation, check if the
product has any defects on it. If
the product is damaged, do not
have it installed.
•
Place the product on a clean,
flat and solid surface and
balance it with adjustable feet.
Otherwise, the product may tip
over and cause injuries.
•
The installation location must be
dry and well ventilated. Do not
place carpets, rugs or similar
covers under the product.
Insufficient ventilation causes
the risk of fire!
•
Do not cover or block the
ventilation openings. Otherwise,
power consumption increases
and your product may get
damaged.
•
Product must not be connected
to supply systems such as solar
power supplies. Otherwise, your
product may get damaged due
to sudden voltage changes!
•
The more refrigerant a
refrigerator contains, the
larger the installation location
must be. If the installation
location is too small, flammable
refrigerant and air mixture
will accumulate in cases of
refrigerant leakage in cooling
system. The required space
for each 8 gr of refrigerant is
1 m³ minimum. The amount of
refrigerant in your product is
indicated on the Type Label.
•
Product must not be installed
in places exposed to direct
sunlight and it must be kept
away from heat sources such as
hobs, radiators, etc.
If it is inevitable to install the
product close to a heat source, a
suitable insulation plate must be
used in between and the following
minimum distances must be kept
to the heat source:
- Minimum 30 cm away from
heat sources such as hobs, ovens,
heater units or stoves,
- Minimum 5 cm away from
electric ovens.
•
Protection class of your product
is Type I. Plug the product in a
grounded socket that conforms
the voltage, current and
frequency values stated on the
type label of the product. The
socket must be equipped with
a 10 A – 16 A circuit breaker.
Our company shall not be
liable for any damages that will
arise when the product is used
without grounding and electrical
connection in accordance
with the local and national
regulations.
•
Product must not be plugged in
during installation. Otherwise,
there is the risk of electric
shock and injury!
•
Do not plug the product
in sockets that are loose,
dislocated, broken, dirty, greasy
or bear the risk of getting in
contact with water.
•
Route the power cable and
hoses (if any) of the product in a