Do NOT use cleaning fluids based on alcohol, methylated spirit or ammonia. The glass
plate has a hard surface coating to prevent scratches. However, the use of strong
chemical cleaning agents may damage this coating. Use only a mild soap or detergent
and water or specially formulated cleaners made for cleaning glass panels.
Avoid direct contact with water or other liquids. Never use the LED monitor in or around
areas where water may pose a potential hazard to normal operation.
Use the LED monitor only indoors, and avoid the contact with oil, vapor, steam, moisture
and dust. The LED monitor should be used in a clean environment with low humidity.
Do not touch the screen directly with your fingers. You may damage the screen, and it is
difficult to remove skin oil from the monitor.
Do not apply pressure to the screen. The LED display is very delicate.
WARNING: Any unauthorised modification of this equipment could result in the
revocation of the authorisation to operate the equipment and void the product warranty.
2. Installation
Do not install the monitor near heat sources such as radiators or air ducts, or in a place
subject to direct sunlight, excessive dust, mechanical vibration or shock.
Do not cover or block the ventilation holes in the case.
Place the monitor on a flat and leveled surface.
Do not remove any of the prongs of the monitor’s three-pronged power plug.
Use an appropriate power cord for your local power supply.
Do not allow anything to rest on the power cord.
Do not locate this product where persons will walk on the cord.
Connect the power supply to the socket and plug the video cable or VGA cable to the
desired signal source.
Use the proper power cord with a correct attachment plug type. If the power source is
120 V AC, use a power cord that has UL and C-UL approvals. If the power source is a
240 V AC supply, use the tandem (T blade) type attachment plug with a ground
conductor power cord that meets the respective European country’s safety regulations,
such as VDE for Germany.
Do not overload wall outlets and extension cords as this can result in a risk of fire or
electric shock.
Ensure that the total ampere rating of all units plugged into the extension cord is not
over the cord’s rating.
2
English
Summary of Contents for GML-2231M
Page 2: ......
