10
3
Installation
3.1 Appropriate installation
location
Contact an Authorized Service for
the installation of the product. In
order to prepare the product for use,
refer the information in the user
manual and ensure that electrical
installation and water installation are
appropriate. If not, call a qualified
electrician and technician to have
any necessary arrangements carried
out.
B
WARNING:
Manufacturer shall not be
held liable for damages
that may arise from
procedures carried out by
unauthorized persons.
B
WARNING:
Product
must not be plugged
in during installation.
Otherwise, there is the
risk of death or serious
injury!
A
WARNING:
If the door
clearance of the room
where the product shall be
place is so tight to prevent
passing of the product,
remove the door of the
room and pass the product
through the door by
turning it to its side; if this
does not work, contact the
authorized service.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as
hobs, heater cores and stoves and
at least 5 cm away from electrical
ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Your product requires adequate air
circulation to function efficiently.
If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the
side walls.
• If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the
side walls. Check if the rear wall
clearance protection component is
present at its location (if provided
with the product). If the component
is not available, or if it is lost or
fallen, position the product so that
at least 5 cm clearance shall be
left between the rear surface of
the product and the wall of the
room. The clearance at the rear is
important for efficient operation of
the product.
• Do not install the product in places
where the temperature falls below
-5°C.
3.2 Installing the plastic wedges
Plastic wedges supplied with the
product are used to create the
distance for the air circulation
between the product and the rear
wall.
1.
To install the wedges, remove the
screws on the product and use the
screws supplied together with the
wedges.
2.
Insert the 2 plastic wedges onto the
rear ventilation cover as illustrated
in the figure.
