21
b.
Timer:
the LED of the selected speed flashes to
indicate that the timer is active.
c. Grease filter saturation:
the
L3
and
L4
LEDs flash
alternately
at short intervals of time.
d. Activated charcoal filter saturation:
the
L3
and
L4
LEDs flash
simultaneously
at short intervals of time.
Reset of the filter saturation indicator: perform
filter
maintenance, then press button
2
until the LEDs turn off.
Note:
The activated charcoal filter saturation is normally
disabled and is enabled only if the hood is used in the filtering
version (with charcoal filter installed).
In order to activate it, proceed as follows:
-
Switch off the hood
-
Keep pressed simultaneously buttons
3
and
4
, until the
LEDs
L1
and
L2
flash briefly.
Repeat the operation to disable; only LED
L1
flashes briefly.
Maintenance
Cleaning
Clean using
ONLY
the cloth dampened with neutral liquid
detergent.
DO NOT CLEAN WITH TOOLS OR
INSTRUMENTS
. Do not use abrasive products.
DO NOT USE
ALCOHOL!
Grease filter
Fig. 3-12
Traps cooking grease particles.
The grease filter
must be cleaned once a month using non
aggressive detergents, either by hand or in the dishwasher,
which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Charcoal filter (filter version only)
It absorbs unpleasant odors caused by cooking.
The saturation of the
charcoal filter
occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four months.
The charcoal filter may NOT be washed or regenerated.
Fig. 12
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times as long as the traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the technical service.
