32
8. Troubleshooting
Drying process takes too much time.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm
water.
• Filter drawer may be blocked>>>clean the foam inside the filter drawer.
• Ventilation grids on the front side of the machine are blocked. >>>
Remove the objects (if any) that block ventilation in front of the
ventilation grids.
• Ventilation is not sufficient since the room where the machine is
installed is very small. Open the door and window of the room to avoid
the room temperature increase too much.
• Lime deposit has built up on the dampness sensor. >>> Clean the
dampness sensor.
• Excessive laundry is loaded. >>> Do not load the dryer in excess.
• Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed
in your washing machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual
dampness level.
• It is likely that the selected programme did not suit the laundry
type.>>>Checking the care labels on clothes, select appropriate
programme for the laundry type or use timer programmes in addition.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm
water.
• Filter drawer may be blocked>>>clean the foam inside the filter drawer.
• Excessive laundry is loaded. >>> Do not load the dryer in excess.
• Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed
in your washing machine.
Dryer does not switch on or the programme does not start. Dryer does not
start when it is set.
• It is not plugged in. >>> Make sure that the machine is plugged in.
• The loading door is ajar. >>> Make sure that the loading door is closed
securely.
• Programme is not selected or the Start / Pause / Cancel button is
not pressed. >>> Make sure that the programme is selected and the
machine is not in Pause mode.
• Childproof Lock is activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
• Loading door is ajar. >>> Make sure that the loading door is closed
securely.
• There was a power failure. >>> Press Start / Pause / Cancel button to
start the programme.
• Water tank is full. >>> Drain the water tank.
