3
If the product is classified by any IP class, never touch the product cover directly with
your fingers, because the acidic sweat of the fingers may damage the surface coating of
the product cover. To clean the inside and outside of the product cover, use a soft and
dry cloth. In any case, do not use alkaline detergents.
The correct configuration of all passwords and other security settings is the sole
responsibility of the installer and/or end-user (this applies especially to IP Cameras and
Recorders).
Special Installation Instructions for IP Cameras
Make sure that the latest firmware is installed on the IP Device. You may get the latest
firmware from
www.grundig-security.com
website or from
.
Do not touch the sensor module with your fingers. Do not aim the camera or camera
lens at a strong light such as the sun or a bright lamp. Irreversible damage to the camera
can be caused by a strong light. Do not expose the sensor of the product to laser beams
as this may damage the sensor.
If the product supports IR, you need to take some precautions to prevent IR reflection.
Do not install the product close to reflective surfaces of objects as this may cause
reflection. If the product has a dome cover, please remove the protection film only after
installation to prevent dust or grease on the camera which can cause reflection. The
foam ring around the lens must be seated flush against the inner surface of the bubble
to isolate the lens from the IR LEDS. Fasten the dome cover to the camera body so that
the foam ring and the dome cover are attached seamlessly.
For cleaning, use a clean cloth with a bit of ethanol and wipe it carefully and gently. In
any case, do not use alkaline detergents.
If a glove is provided in the package, please use it to open the product cover. Never
touch the product cover directly with fingers, because the acidic sweat of the fingers
may damage the surface coating of the product cover.
Summary of Contents for GD-CI-AP4746P
Page 1: ......
