Step 3:
Unscrew the module-fastened screw, as indicated in the
picture.
Step 4:
Press the sides of the snap-on module, as indicated in the
figure, and detach it from the Dome Camera’s housing.
Step 5:
Mark the positions of the four screw holes on the base of the
Dome Camera at the chosen installation location.
Step 6:
At the marked locations, drill each hole slightly smaller than the screw anchors.
Step 7:
Put the anchors into these drilled holes.
Step 8:
Fasten the Dome Camera’s housing with four self tapping
screws. Please use the supplied rubber washers for sealing
the self tapping screws.
5
English
