Step 17:
Put the Dome Cover back, aligning the arrow mark on the
Dome Cover with the one on the housing as shown in the
picture.
Step 18:
Screw on the two Torx screws on the side of the Dome Cover
tightly to fasten the Dome Cover. The Camera installation is
now complete.
4.6. 4S Mount Electrical Box
Before installing the IP Dome Camera in the 4S Electrical Box, please unscrew and open the Dome Cover with the
Security Torx. In the picture below you can see a 4S Mount Electrical Box.
Step 1:
Run the wires (Ethernet and power) through the wall.
NOTE: The power cable is omitted if using PoE.
Step 2:
Disassemble the Dome Camera’s Inner Cover (see the illustration in chapter 4.5. Hard Ceiling: Step 3) from the
Dome Camera unit.
Step 3:
Detach the snap-on camera module from the Dome Camera’s housing by unscrewing the module-fastened cross
head screw first. Then press the sides of the camera module and pull it out of the housing.
8
English
