Grundfos Multilift MSS, Installation And Operating Instructions Manual

Page: 8 / 400

English (GB)
8
Nameplate, pump
The nameplate is printed on the pump.
Fig. 3 Nameplate, pump
5.1.3 Non-return valve
The DN 80 non-return valve includes a drain screw to lift up the
internal flap in order to drain the outlet pipe in case of
maintenance or service. The valve is designed and tested
according to EN 12050-4. See fig. 4.
Fig. 4 Non-return valve
5.1.4 Level sensor
The piezoresistive pressure sensor placed in the controller is
connected via a hose to a pressure tube in the tank. The screw
cap where the hose is connected includes a connection for a DN
100 tube. This tube, the pressure tube, extends down into the
tank. The rising liquid level compresses the air inside the
pressure tube and hose, and the piezoresistive sensor transforms
the changing pressure into an analogue signal. The control box
uses the analogue signal to start and stop the pump and to
indicate high water-level alarm. The pressure tube is fixed
underneath the screw cap and can be taken out for maintenance,
service and for cleaning the inside of the tube. An O-ring ensures
tightness.
The hose is supplied in lengths of 4 or 10 m. The hose must be
connected to the controller.
Fig. 5 Screw cap with hose, DN 100 tube
TM
0
5
1
1
94
24
11
Pos. Description
1 Type designation
2 Product number
3 Rated voltage
4 Frequency
5 Rated
current
6 Rated speed
7 Rated power input
8 Weight
9
Maximum flow rate
10 Maximum head
11 Approvals
12
Production week, year and day
13 Maximum liquid temperature
14 Maximum installation depth
15 Power factor
16 Insulation class
17 Enclosure class
Note
Loosen the lock nut a little before turning the drain
screw.
T
M
05
03
40
10
11
Drain screw
TM
05
03
32
10
11