En
gl
is
h (
G
B)
22
6.3 Main menus
The main menus are displayed as symbols at the top
of the display. The currently active main menu is
displayed as text.
6.3.1
Operation
Status information such as the dosing flow,
selected operation mode and operating state
is displayed in the "
Operation
" main menu.
6.3.2
Info
You can find the date, time and information
about the active dosing process, various
counters, product data and the service system status
in the "
Info
" main menu. The information can be
accessed during operation.
The service system can also be reset from here.
Counters
The "
Info
>
Counters
" menu contains the following
counters:
6.3.3
Alarm
You can view errors in the "
Alarm
" main
menu.
Up to 10 warnings and alarms, together with their
date, time and cause, are listed in chronological
order. If the list is full, the oldest entry will be
overwritten, see section
.
6.3.4
Setup
The "
Setup
" main menu contains menus for
pump configuration. These menus are
described in the following sections.
* These submenus are only displayed for specific
default settings and control variants.
The contents of the "
Setup
" menu also vary
depending on the operation mode.
T
M
0
4
1
1
57
201
1
TM
04
1
1
0
6
1
010
Counters
Resettable
Volume
Total dosed volume [l] or US gallons
Yes
Operating hours
Accumulated operating hours (pump
switched on) [h]
No
Motor runtime
Accumulated motor runtime [h]
No
Strokes
Accumulated number of dosing
strokes
No
Power on/off
Accumulated frequency of switching
mains voltage on
No
Operation
7.48
l/h
Manual
7.48l/h
Th
Backpressure
Counters
Service
ServiceKit
Reset service system
Software rev.
Serial no.:
Product no.:
Type Key:
Info
18.02.2010
12:34
15.0bar
>
-
V0.20
TM0
4
1
1
09
10
10
Note
Check all pump settings after any
change in the "
Setup
" menu.
T
M
04
1
11
0 10
1
0
Alarm
12.02.2010
12.02.2010
1
Empty
2
Low level
12:34
12:34
Delete alarm
messages
❑
Setup
English
>
Pulse
>
❑
>
1.06 l
7:50
>
>
Actual flow
>
Off
>
❑
>
>
❑
❑
>
Off
>
>
>
>
>
>
Language
Operation mode
Pulse memory
*
Analog scaling
Batch volume
*
Dosing time
[mm:ss]*
Dosing timer cycle
*
Dosing timer week
*
Analog output
SlowMode
FlowControl active
*
FlowControl
*
Pressure monitoring
*
AutoFlowAdapt
*
Auto deaeration
Calibration
Key lock
Display
Time+date
Bus
Inputs/Outputs
Basic settings
Section
5.1
6.4
6.4.2
6.4.3
6.4.4
6.4.4
6.4.5
6.4.6
6.5
6.6
6.7
6.7
6.8
6.10
6.11
5.3
6.12
6.13
6.14
6.15
6.16
6.17
