Eng
lish (US)
22
9.3 DLC, float-switch-controlled option
The alarm screen will only be displayed when alarms are active. The alarm screen shows the date and time when the alarm started.
9.4 DLC, transducer-controlled option
The alarm screen will only be displayed when alarms are active. The alarm screen shows the date and time when the alarm started.
Alarm screen Alarm text
Description
1
High Level Alarm
High level alarm
2
Pump 1 Fail Alarm
Pump 1 failure alarm
3
Pump 2 Fail Alarm
Pump 2 failure alarm
Data screen
System data
Description
4
Pump 1 CT & ETM
Pump 1 cycles are shown at the top of the screen and pump 1 run time beneath.
5
Pump 2 CT & ETM
Pump 2 cycles are shown at the top of the screen and pump 2 run time beneath.
6
High Lvl CT
High level alarm events
7
Pump 1 & 2 Lag Event
Counters
Pump 1 lag (standby) events are shown at the top of the screen and pump 2 lag
(standby) events beneath.
8
Power Fault Counters
Power failures are shown at the top of the screen and hours in service beneath.
9
Pump 1 & 2 Fault Counters
Pump 1 failure events are shown at the top of the screen and pump 2 failure events
beneath.
Alarm screen Alarm text
Description
1
Xducer Sig
Is activated when the transducer signal is below 3 mA.
2
High Level Alarm
When lifted, this float switch activates the alarm indication on the screen and the audible
alarm.
3
Low Level Alarm
When lowered, this float switch stops the pump and activates the indication on the
screen.
4
Pump 1 Fail Alarm
Is activated when pump 1 overtemperature sensor, seal failure sensor or overload relay
has tripped.
5
Pump 2 Fail Alarm
Is activated when pump 2 overtemperature sensor, seal failure sensor or overload relay
has tripped.
Data screen
System data
Description
6
Current Tank Level
Liquid level in tank or pit in feet
7
Pump 1 CT & ETM
Pump 1 cycle counter is shown at the top of the screen and pump 1 run time in minutes
beneath.
8
Pump 2 CT & ETM
Pump 2 cycle counter is shown at the top of the screen and pump 2 run time in minutes
beneath.
9
High Lvl CT & Low Level CT
High level alarm counter is shown at the top of the screen and low level alarm counter
beneath.
10
Power Faults & Operating Hr
Power failure counter is shown at the top of the screen and operating hours beneath.
11
Transducer Signal
Raw value of transducer reading, in mADC
12
On/Off Level Settings
Pump on and off level setpoints
13
Lag Level Setting
Lag (standby) pump on level setpoint
14
High/Low Level Settings
High- and low-level alarm setpoints
15
Transducer Input
Transducer range and offset settings
16
Minimum Run Time
Minimum pump run time per cycle
17
High Level Pump Run Time
Minimum high level pump run time per cycle
18
High Level Alarm Delay
Elapsed time between high level point and alarm activation
Summary of Contents for 99107059
Page 46: ...46...
