English (GB)
5
3.3.2 Positioning the control box in air-conditioning and
cold-water systems
Position the control box with the plug pointing downwards. See
fig.
.
Fig. 4
Control box position, air-conditioning and cold-water
systems
3.3.3 Changing the control box position
To change the position of the control box, do as follows:
3.4 Insulating the pump housing
You can reduce the heat loss from the product by insulating the
pump housing with the insulating shells supplied with the pump.
See fig.
Fig. 5
Insulating the pump housing
TM
07
1
1
2
7
0
218
Step Action
Illustration
1
Remove the four
screws.
TM
05
55
38
38
12
2
Turn the pump
head to the
desired position.
You can turn the
control box in
steps of 90 °.
TM
05
55
39
38
12
3
Insert and
cross-tighten the
screws.
TM
05
55
40
38
12
CAUTION
Hot surface
Minor or moderate personal injury
- Position the pump so that persons cannot
accidentally come into contact with hot surfaces.
CAUTION
Pressurised system
Minor or moderate personal injury
- Before dismantling the pump, drain the system or
close the isolating valve on either side of the
pump. The pumped liquid may be scalding hot and
under high pressure.
If you change the position of the control box, fill the
system with the liquid to be pumped or open the
isolating valves.
T
M
05
30
58
09
12
Do not insulate the control box or cover the operating
panel.
