English (GB)
15
7. Setting the product
All settings to the pump is made via the Grundfos GO Remote
app, which is available for iOS and Android devices and free of
charge. Grundfos GO Remote connects to the pump via
Bluetooth.
In addition you can select four different operating modes via the
pump’s operating panel. See section
mode using the operating panel
.
Fig. 28
Operating panel
7.1 Light fields indicating the pump setting
The pump setting is indicated by four light fields in the display.
See fig.
(3). The settings are configured via the Grundfos GO
Remote app.
Factory setting
The pump is factory set to radiator mode.
For information about the control settings, see section
7.2 Connecting the pump to Grundfos GO Remote
ALPHA3 is designed to communicate with the Grundfos GO
Remote app. Before connecting, you must download the app.
To connect do as follows:
1. Turn on Bluetooth on your smart device.
2. Open Grundfos GO Remote.
3. Choose to connect via Bluetooth. If you connect via the "List"
button, choose "ALPHA3" from the list.
Follow the instructions given in Grundfos GO Remote.
4. When the pump detects that Grundfos GO Remote is trying to
establish connection, the connectivity symbol on the pump
operating panel starts to flash blue. See fig.
(A).
When Grundfos GO Remote is connected to the pump, the
symbol on the operating panel is permanently on. See fig.
(B).
Fig. 29
Operating panel when connecting the pump to
Grundfos GO Remote
TM
07
0
7
85
03
18
Pos.
Description
1
QR code: When scanned with Grundfos GO Remote
you get access to detailed product information,
documentation and service information. The QR
scanner is found in the app's side menu.
2
Four light fields indicating the pump setting.
3
Connectivity button: Push-button for connecting the
pump to Grundfos GO Remote and Grundfos GO
Balance.
The button can also be used for setting the pump’s
operating mode.
4
Light field indicating either the actual pump power
consumption in watt or the actual flow rate in m
3
/h in
steps of 0.1 m
3
/h during operation.
5
Alarm and warning indication. See section
.
6
Connectivity symbol. When lit, the pump is connected
to Grundfos GO Remote.
7
Push-button for selection of parameter to be shown in
the display, that is actual power consumption in watt
or actual flow rate in m
3
/h
.
ALPHA3
1
2
3
4
5
6
7
Active light fields
Description
Radiator mode
Underfloor mode
Radiator and underfloor mode
User set control mode
(proportional-pressure,
constant-pressure and constant-curve
mode) including min. and max.
operation mode.
T
M
07
12
11
1
118
When the pump connects to Grundfos GO Remote, a
setup wizard automatically pops up after
approximately two seconds.
ALPHA3
ALPHA3
A
B
