Ensure that reflectors strips are
secured to inside ver.cal face of
base frame:
Step 1:
Cut buUonholes in rubber seal to
push Tie Strap legs through.
Step 2:
Push leg of Tie Strap closest to
frame through and bend over (this
is the leg that keeps underslung
frame 6ght against ceiling).
Step 3:
Same for second Tie Strap per
reflector side
Step 4:
Slide cheek plate reflector strip into
“V” between legs of Tie Strap.
Step 5:
Feed inside leg of Tie Straps through
same buUon hole of rubber seal and
bend over (to fix reflector
permanently in posi6on).
Summary of Contents for Sungazer
