3
Revision date: 01.28.20
Important Information
PARTS IDENTIFICATION
The following graphics and photos help identify hardware
for the door. (Some parts are not shown.)
Twin-Wall Black-Out Polycarbonate Door Kit
102921B & FA4484B
Tek Screws and neo-
bonded washers
104213
Aluminum
U-Channel Profile
108553
Wafer head screw
CARE AND MAINTENANCE
Proper care and maintenance of the door is important.
Check the following items periodically to properly maintain
door and door frame:
• Regularly check polycarbonate panel to ensure it
remains secure and is in good condition. Replace
damaged panel if needed.
• Check connections and all fasteners to verify that they
remain tight.
• Check contents of shelter to verify nothing is touching
polycarbonate panel that could cause damage or
interfere with door operation.
• Do not leave door partially opened. Close door and
secure with latch or prop open to avoid personal injury
or damage.
• For replacement or missing parts, contact your sales
representative.
SINGLE SWINGING DOOR KIT: READ THIS BEFORE
YOU BEGIN
Consult the services of a qualified contractor if needed.
It
is the responsibility of the owner/contractor to adapt these
instructions to safely and competently install this door in
an end wall or building that it was not designed for.
Complete these steps:
1. Based on door dimensions, determine door position
in end frame. Use diagrams from both this guide and
end wall assembly guide (if availble).
2. Return to end wall instructions and frame end wall as
needed based on door location. Secure door framing
to end wall framing.
3. Assemble door and attach to door frame.
IMPORTANT NOTICE:
Remove protective film from the
polycarbonate panel. Allowing film to remain intact and
in direct sunlight will make it difficult if not impossible
to remove.
Store panel out of direct sunlight until film is
removed.
Rest panel edges on cardboard or other material to
protect it from dirt and damage during assembly.
Protective Film
Mark UV-protected side with a piece of tape after
protective film is removed and install that side
toward sun.
