CUTTER BLADE
Check for wear and tighten the mounting bolts:
It is important not to allow the cutter blade to become
loose
The three blade mounting bolts ’A’ should be checked
and tightened five working hours after initial fitting and
every 30 working hours there after. On a level surface, tilt
the machine forward to rest on the front chassis nose and
use the tee wrench supplied to tighten the bolts.. If the
cutting edge on the cutter blade cross knife or side knives
is rounded and dull, the blade should be removed for
sharpening. This should be done by a service workshop.
The cutting bevel should be ground on the upper face of
the blade cross knife and on the outermost faces of the
side knives. If the blade cross knife is worn to less than
2/3 its original width it will not enter the ground effi
ciently and must be replaced.
RUNNING MAINTENANCE
A
Page 13
MAINTENANCE SUMMARY
Frequency
Operation
Type / Quantity
Tyres
20 hrs
Check Pressure/Condition
18 psi
Levers
20 hrs
Oil
EP 90
Jockey Wheels
20 hrs
Oil
EP 90
Blade
30 hrs
Tighten or Replace
Blade Part No TMCSB**
Air Filter
50 hrs
Clean or Replace
See Honda Manual
Engine Oil
80 hrs
Top Up
SAE 10 W 30
Main Belt
100 hrs
Adjust or Replace
Belt Part No BPC113
Blade Drive Belt
300 hrs
Adjust or Replace
Belt Part No BPC140
Gear Oil
300 hrs
Top Up
EP 90
