3
1
2
6
7
5
CAUTION
Keep clear of the raised unit at ALL TIMES. NEVER
enter the underside of the shell for any reason
unless it is being held by suitable supports
(correctly rated axle stands for example).
DO NOT use the hydraulic jacks as a means of
support. Use them ONLY for changing the unit
from road towable to static and vice versa.
Arrival at site
Lower rams by pressing UP button
(1)
on
control box
(Fig A)
until road wheels are clear
of ground
Move spring bolt
(4)
into open position
(Fig B)
Pull lever
(5)
into open position
(Fig C)
Remove jockey wheel
(6 & 7)
, by turning
anti-clockwise, release locking handle, remove
jockey wheel, handle and pad
(Fig D)
Release handbrake to “Off ” position
Fig E
shows removed jockey wheel
Press DOWN button
(2)
on control box
(Fig A)
to lower unit to the ground
Lower steel shroud over drawbar and lock in
closed position
Departure from site
Open shroud and secure in upright position
with Securing Bolt (Anti Luce) and Safety Clip
(Pin & Chain)
(Fig F)
Pull handbrake to the “ON” position
Press UP button until road wheels are clear of
ground
Replace jockey wheel into its clamp with the
pad and locking handle, rotating jockey wheel
handle clockwise to attach lower wheel shaft
Push lever
(5)
to lock axle pins
Release spring bolt
(4)
Press DOWN button
(2)
to raise the rams until
the unit is level, on its wheels, supported by
jockey wheel
Continue to press DOWN button to fully retract
hydraulic rams
Single axle electric
hydraulic operating
instructions
– press button
A
B
D
F
C
E
4
User’s Guide
|
Mobile GP360 & GP500 Fusion Pulse Units
www.groundhog.co.uk
|
13
Single axle operating instructions
Section
8
